Edson Clutch and Throttle Controls: Installation Guidelines
1. All Edson engine controls are designed to be used
with only those engine transmissions having detents to locate
and hold the transmission in gear.
2. Lead cables under the deck using a minimum number of
bends with a generous radius. The degree of bend in the
cable, when all bends are added together, should not
exceed 270 degrees. Tape or clamp to several structural
members to reduce cable lost motion and prevent
interference with sheaves and wire rope.
3. Cables may be adjusted by screwing the clevises at the
engine control or engine end in or out, or by attaching the
clevis at a different position on the shift or throttle levers at
the engine end.
4. If engine vibration causes unwanted throttle movement,
adjust throttle friction adjuster.
5. Those on board must be familiar with the maintenance
and operation of the controls. All screws must be kept
tight and cotter pins properly secured.
Order
your Edson Clutch & Throttle Controls
|