Edson Pull-Pull Conduit Systems are designed to provide the ability
to run steering cables around spaces or structures that otherwise
might be difficult or impossible with straight wire runs from sheave
to sheave. Edson Pull-Pull System components have been engineered to
allow you to use stock parts that will result in a strong, reliable and
sensitive steering system.
 Edson In-Out Conduit Idler
Edson’s In-Out Conduit Idler is designed to increase the efficiency
and sensitivity of a Pull-Pull Conduit System. Engineered with 6”
sheaves and three holes to accept Edson’s Conduit End Fittings,
the idler makes wire alignment with the sheave automatic. It is
recommended that these idlers be used at major load points in engine
compartments to allow the steering cable to run over a sheave when
being routed aft.
Order
online |
