HRC 10-10 Horizontal Windlass - 24V, 3/8" Chain & 5/8" Rope

Maxwell's all new HRC Horizontal Series represents yet another breakthrough in performance and anchor handling excellence. These horizontal, fully automatic rope/chain windlasses have been designed to meet the demands for use on larger vessels up to 16 metres (52 feet), which require a completely above deck installation system. The HRC's flawlessly handle rope up to 16mm (5/8 in) and chain up to 10mm (3/8 in) in size, including the thick rope to chain splice.

The modern appearance of the HRC Series retains the classic good looks of previous Maxwell horizontal windlasses, while incorporating design features years ahead of its competitors.

Our Part # MAXHRC101024V | Maxwell Part # HRC101024V

Features:

• Aesthetically pleasing above deck design encapsulates the motor and drive in a two part watertight case.
• The two part case consists of a die cast, marine-grade hard anodised alloy front section and a rugged and easily removable composite motor cover aft section.
• This two piece watertight case allows for quick and easy, on-deck, routine maintenance.
• Simple bolt down installation ensures effortless and rapid on-deck installation and set up.
• The stainless steel pressure arm always exerts maximum control pressure on the rode (rope, splice or chain).
• The new and revolutionary patented Wave Design™ chainwheel is able to accommodate a wide range of chain pitch differences, within the specified chain size diameters, suitable for use with the HRC10 Series.
• The unique Maxwell wrap around-horizontal chainwheel ensures that more than 90° of the wheel is used, allowing greatly improved rope and chain handling compared with competitor designs.
• Works effectively with all-chain rodes.
• The integral chain pipe and huge, through deck hawse pipe throat ensures easy entry of the rope/chain rode into and out of the anchor locker.
• Cone type clutch/brake mechanism permits manual, free fall anchoring and emergency crank recovery of the rode.

Includes:

• Windlass.
• Dual direction solenoid pack.
• Emergency crank/clutch release handle.

Extras:

• Up/down remote control panel.
• Circuit breaker/isolator panel.

*Important: Maxwell windlasses must be used in conjunction with a chain stopper or alternative snubbing device to take the load off the windlass while laying at anchor. The chain stopper and alternative snubbing system should also be used to secure the anchor in the fully raised position while under way.

Click here for specifications.

Click on the following technical articles to find relevant information about Windlasses:

• Selection Guide: "Chain Dimensions - Choose the best one for your needs!"